Arrived on site and fabricated the door latches then welded them into place everything works properly then cut the tops of the posts off and put the caps on then moved everything to the back gate and welded a clip on the sagging post and then anchored it to the wall then moved the latch down so the gate can close properly.

Started to remove chain operation components Switched out chain bracket inside to bracket intentes for motor operation Got motor up and got door to run on manual operation Started running conduit Got photo eyes to run as a safety for the door Ran all wire and wired in door Door wouldn\'t run due to photo eye cable was cut Fixed issue and got door to run onto key switch operation.

Arrived on site got access the garage car remotes stopped working on garage opener cleared. All remotes that were on opener. Went to program new remote program button on remote learn button on operator until indicator light was on then tried programming. A station remote would not program an operator would back out of learn mode. Customer states they have numerous garage doors down and that he ordered Chamberlain operators for the garage.

Rytec Turbo Seal Insulated # 601417 replaced battery and noticed door would only close halfway and counter weights were bottoming out at the bottom. Adjusted straps so weights were 8\" off ground. Tried cycling door again but it would only close halfway. Got door to position where it seems to bind and went up to look and found vinyl is coming apart from foam in a 8 to 10 inch section all the way across door not allowing it to pass the idler roller and header.

WORK PERFORMED: Installed replacement take up reel Installed timer to close board Cleaned up left over trash.